Creating Rollback/Rollforward zones for payload maps

This article or section needs a screenshot to help visually convey the subject.
You can upload screenshots at Special:Upload. For help, see Help:Images.

Note:You should already have the knowledge to create a payload map in order to use this tutorial. Please visit this tutorial before you continue reading.

Basic Roll Forward/Backward

Go to the path_track(s) you want your cart to roll forward/back. Go to the flags, and you should tick one of the last two flags. This will tell the team_train_watcher that the path_track the cart is currently moving on will roll back/forth if nobody pushes it while it is in the zone.

Additional Info

Slower than usual rollback zones

If you want to make it slower than the default speed while is is pushed up, go to the path_track at the beginning of the rollback zone. Go to outputs and put them to these settings:

	My Output	Target Entity	Target Input	Parameter	Delay	Only Once
	OnPass	Watcher_A	SetSpeedForwardModifier	0.5	0.00	No
	OnPass	Name of the path_track before this one	DisablePath	<none>	0.00	No

Then, go to the path_track at the end of the rollback zone, and set the outputs:

	My Output	Target Entity	Target Input	Parameter	Delay	Only Once
	OnPass	Watcher_A	SetSpeedForwardModifier	1	0.00	No

Voila! You're done!

Faster than usual rollforward zones

Do the same as the "Slower than usual rollback zones", only you must go to the path_tracks at the beginning and end of the rollforward zone, and you change the outputs around a bit.

Outputs for start of the zone:

	My Output	Target Entity	Target Input	Parameter	Delay	Only Once
	OnPass	Watcher_A	SetSpeedForwardModifier	1.5	0.00	No

Outputs for end of the zone:

	My Output	Target Entity	Target Input	Parameter	Delay	Only Once
	OnPass	Watcher_A	SetSpeedForwardModifier	1	0.00	No
	OnPass	Name of the path_track before this one	DisablePath	<none>	0.00	No

Then you're done! I hope this tutorial helped!