Ricochet Level Creation/Jump arrow/en
Language subpage
This subpage is used on the Ricochet Level Creation/Jump arrow page to display content in English.
If you have edited the language subpage, do not forget to purge the base page by clicking on the button on the right. Otherwise, its contents will not be updated.
Players in Ricochet can only jump using jump arrows and jump pads.
Jump arrow
- Cut the area where you what to attach jump arrow at off pad using the Clipping Tool. Paint the clipped face with
SKY
texture. - Create 80x36 16 units tall block and make it
func_wall
. Cover it inNULL
texture. - Make pyramid off new block using the Vertex Tool, as shown in the Stage 3.
- Remove the top half of the pyramid using the Clipping Tool.
- Paint top and bottom sides with
+0ARROW1
texture. Rotate texture to same direction as brush and press Fit and C on texture application window. Paint left and right sides with+0SQUARE1
texture with 180° rotation and Fit button pressed. - Place
trigger_jump
brush entity above jump arrow. Setinfo_target
of the target pad or jump pad as Target keyvalue, and Height to the height difference between two pads, usually 128. - Rotate the arrow and trigger and attach them to pad.
Jump pad
- Create 112x32x96 block. Place it 96" above platform.
- Make a pyramid off the block.
- Paint pyramid sides with +0ARROW1 texture, back side with BLACK texture. Make it
func_wall
. - Put info_target and
trigger_jump
at the spike. Set info_target from target pad as trigger_jump's Target keyvalue. - Rotate the arrow and trigger.