Switch

← Portal Level Creation

This tutorial will show how to create the switch seen throughout the later test chambers of Portal. The switch is activated by a player using it, and can either be permanently pressed, or stay pressed for a set amount of time.

Creation

Step 1

The base brush

Create a 32w*64l*8h brush. Texture the sides of the brush with signage/hazard_orange_03b, and texture the top of the brush with concrete/concrete_modular_floor001a.

Step 2

The switch model

Create a prop_dynamic entity and set its World Model to models/props/switch001.mdl, and set its Name to switch1.

Step 3

The ambient_generic entities

Create a ambient_generic and set its Name to button1_down, its Sound Name to Portal.button_down, and its Source Entity Name to switch1. Create another ambient_generic and set its Name to button1_up, its Sound Name to Portal.button_up, and its Source Entity Name to switch1.

Step 4

The timer setup

Create a logic_timer entity. Set its Name to timer_ticktock1, set Start Disabled to Yes and set its Refire Interval to 1. Next, create an ambient_generic entity and set its Name to sound_ticktock1, set its Sound Name to Portal.room1_TickTock, set its Max Audible Distance to 441 and set it Source Entity Name to switch1. Now add the following output to timer_ticktock1:

	My Output	Target Entity	Target Input	Parameter	Delay	Only Once
	OnTimer	sound_ticktock1	PlaySound		0.00	No

Step 5

The func_door_rotating brush

Create a 32w*32l*32h brush 32 units above the bottom of the switch model. Texture it with tools/toolsplayerclip and tie it to a func_door_rotating entity. (Alternatively, you can use a func_button with the flags Don't Move and Use Activates enabled.) Set its Speed to 500, its Distance to 0 and its Delay before reset to how long it should stay pressed for, in seconds. Set it to -1 to make it stay pressed forever after being activated. Next, check the Use Opens and Door Silent flags. Next, add the following outputs to the door:

	My Output	Target Entity	Target Input	Parameter	Delay	Only Once
	OnOpen	switch1	SetAnimation	down	0.00	No
	OnFullyOpen	button1_down	PlaySound		0.00	No
	OnFullyOpen	timer_ticktock1	Enable		0.00	No
	OnClose	switch1	SetAnimation	up	0.00	No
	OnFullyClosed	button1_up	PlaySound		0.00	No
	OnFullyClosed	timer_ticktock1	Disable		0.00	No

The switch is now finished and ready to be implemented in a map.

Implementation

The switch in-game

Step 1

Place the switch where it should be in the map. Rotate it if necessary.

Step 2

Add the outputs that should fire when the switch is activated. The outputs that should fire when the switch is pressed should be the OnFullyOpen output on the func_door_rotating entity, and the OnFullyClosed output when the button is reset after its timer has run out.

See Also

• Button (Portal 2) - Portal 2 counterpart