Creating Portal Vacuum Tubes

← Portal Behind The Scenes Level Creation

Introduction

This guide will teach you how to create Vacuum Tubes.

Warning: This page is incomplete, it's recommended that you don't follow the guide until it's finished

Setting Up

Put prop_static entities. Set their model to these:

• Straight Tube - clear_tube_straight.mdl
• Mutli-Directional Tube - clear_tube_tjoint.mdl
• Broken Tube - clear_tube_broken.mdl
• 90 Degree Tubes - clear_tube_90deg.mdl

Enter the following properties:

Property Name	Value
Collisions	Not Solid

Create your path with the models.

Vacuum Tube Path

Walls

Create walls with the nodraw texture, texture the inside faces or visible faces with metal/metalwall_bts_006a. Create orange pits as well.

Vacuum Tube Walls

Simple Collisions

Put brushes around the tubes with the invisible texture. Turn all of these brushes to a func_detail. The wall brushes should be 24 units in Width and the ceiling and floor brushes should be 32 units in width.

Vacuum Tube Collision

Movement

Horizontal Movement

Create brushes with the Trigger texture 32 units high and 80 in width, the length will depend on how long your tube is.

Vacuum Tube Collision

Tie each individual brush to a trigger_push entity and enter the following properties:

Enter the following properties:

Property Name	Value
Speed of Push	350

Tick the Clients flag and set its Push Direction to the direction your tube will go.

Horizontal Movement

If your pipes require you to move up, you need to create an 80w*80l*16h brush with the Invisible texture, tie it to a func_door entity and enter the following properties:

Property Name	Value
Name	door_push_up_pipe
Speed	200
Forced Closed	Yes
Move Direction	-90 0 0

Under flags, untick Touch Opens and tick Door Silent. Set the lip value to a negative value to move the door upwards.

Todo: Finish the rest of the guide

See Also

• Portal Behind The Scenes Level Creation

• Portal Level Creation