$jointconstrain

Usage

$jointconstrain (Name) (Axis) (Type) (MinRange) (MaxRange) (Friction)

A QC command used to set the limit of a joint's movement when compiling the collision model. For example, to limit joint_spine on the X axis with a range from 20 to 100 and a set friction of 0.20, add this line to the .QC file: $jointconstrain "joint_spine" x limit 20.00 100.00 0.20.

Parameters

Name

Name of the bone.

Axis

X, Y, or Z.

Type

• Free

The joint can move between a MinRange of -360 and a MaxRange of 360 with a selectable Friction. Note that user specified MinRange and MaxRange values are ignored.

• Fixed

The joint does not move at all. The MinRange, MaxRange, and Friction values are locked at 0.

• Limit

The joint is completely customizable. The user must specify MinRange, MaxRange, and Friction values.

MinRange

If allowed, sets the minimum range allowed for this joint in degrees. (No lower than -360)

MaxRange

If allowed, sets the maximum range allowed for this joint in degrees. (No higher than 360)

Friction

If allowed, sets the Friction value.

See also

• QC Commands