Creating Cat Walks

Stub

This article or section is a stub. You can help by expanding it.

Introduction

This guide will show you how to create Cat Walks seen in testchmb_a_15 and escape_02.

Warning:This guide is unfinished, as of right now, it is recommended that you do not follow this guide until it is finished.

Most of the catwalk will be 64w*384l*4h.

Set the bottom and top texture to metal/metalfloor_bts_001b

Set the side textures to metal/metalbeam_bts_001a.

Enter the following properties with the Face Edit Sheet:

Texture Scale:

Texture Shift:

Note:Change the length to how long your Cat Walk needs to be, it does not have to be 384 units.

If the beginning or end of the path is a 128 unit tall and wide walk way, create a 128w*128l*4h brush on the entrance/exit.

Path Type 1

If the beginning or end of the path is a 128 unit tall and 64 unit wide walk way, just use the 64w*384l*4h brush.

Path Type 2

If your Cat Walk has multiple directions it can go, create another brush on the side of the

Path Type 2

You can include details such as handrails falling off, broken flooring, floor pieces, etc...

These cat walks are seen in escape_02 in the room containing the GLaDOS chamber and the cat walks on the very top in the turret room.