Looping a sound

Intro

In this short tutorial you will learn how to loop a .wave sound file. (.mp3 can't be looped via cue points) Looping sounds in Source requires a simple short process to be made. Sounds cannot be simply looped by un-checking the Is NOT Looped flag of a ambient_generic. Instead you must add cue points to the sound file. To do we must use a program called Goldwave. Download it here. There is a free trial version available, after it ends you will need to buy Goldwave. Once it is installed you are ready to begin.

Adding the loop

Open Goldwave and open the sound you want to loop. Click the cues icon. () Then in the new window click on the New button and add a cue point At Start. Then click New for another cue point and add a point At End. So it looks similar to this:

Conclusion

Save your file and it's loop-ready. Now when you use a ambient_generic and un-check the Is NOT Looped flag with your sound it will loop in game correctly. On a side note, you can also decide to set the starting cue point right in the middle of the wave sound. Basically, the engine will play the sound quite normally from the start, and when it will reach the end, instead of jumping back to the begining of the sound, it should go back to the first cue point. For example, it could be used for a motor sound, where the engine starts and then idle for a moment. The idling part could be looped without the startup part.

See Also

• ambient_generic
• Goldwave - Official website