Creating an Observation Hallway

This article or section needs to be cleaned up to conform to a higher standard of quality.
For help, see the VDC Editing Help and Wikipedia cleanup process. Also, remember to check for any notes left by the tagger at this article's talk page.

← Portal Level Creation

This is a tutorial for Portal.

Introduction

Making bts (behind the scenes) style observation halls is a simple job. It takes little time, especially with prefabricated items.

Due to the highly detailed nature of observation rooms, this tutorial will be provided in images. Reading order is left to right, then down.

Note:The circular ceiling light can be copied and pasted from the example Portal map included with the Source SDK

Tutorial

Base Layout

• 

  Create the floor for your hallway. Create minimal paths to cause less confusion. Hallways are generally 128 units wide.

• 

  Add the walls (128 units tall)

• 

  Texture the floor and walls, then copy the walls, resize to 64 and re texture (floor texture: tile/observation_tilefloor001a. wall textures: concrete/observationwall_001a for the wall that matches with the ceiling, concrete/observationwall_001b for the wall that matches with the floor. Typing only "observation" will show a more general list of observation hallways skins.)

• 

  Add the roof (texture: plastic/plasticwall002a)

Light Sources

• 

  Add the light bars around the perimeter. These are 4 units thick. (white009)

• 

  Create the base for the light. 160x120x16. Cut two wedges on the ends.

• 

  Make a hole in the center, 96x96 units.

• 

  Create an arch as shown.

• 

  Select the whole arch, and clip it square. Make it a func_detail.

• 

  Seal the func_detail.

• 

  Texture the light. Make the inside light, white009 with a scale of 50. The outside part of the light should have the same texture of your ceiling.

• 

  Add a light_spot and a point_spotlight. Set the light_spot brightness value to 183 204 218 600. Set the point_spotlight color value to 183 204 218.

• 

  Group the light and place in multiple locations^[Clarify].

• 

  Cut away the roof where the light goes.

Detailing

• 

  Add doors.

• 

  Create the detailed fuse sets.

Final Steps

• 

  Final result. (Use expert compile for proper shadows)