Func portal bumper

Not using a portal bumper

How to place the bumper in Hammer

The result - a portal will be bumped to fit on the concrete

This brush tells Portal to 'bump' portals that cannot open inside it away. Use it when a portal-proof surface runs directly on to a portal-friendly one.

You don't need to use one if there is an angle in the surface (e.g. the corners of a room).

Note:Each func_portal_bumper must stick at least two units out from the surface.

Keyvalues

Name (targetname) <string>[ Edit ]

The name that other entities refer to this entity by, via Inputs/Outputs or other keyvalues (e.g. parentname or target).
Also displayed in Hammer's 2D views and Entity Report.

See also:  Generic Keyvalues, Inputs and Outputs available to all entities

Parentname:

Parent (parentname) <targetname>

Specifies a movement parent. An entity will maintain its initial offset from its parent. An attachment point can be added to the end of the name, separated by a comma.

Flags

• 1: Start inactive

Inputs

• Activate

Turn on bumping functionality

• Deactivate

Turn off bumping functionality

• Toggle

Toggle bumping functionality

Outputs

• Template:O targetname