|
|
| Line 1: |
Line 1: |
| {{lang|{{FULLPAGENAME}}}}
| | |
| <onlyinclude>{{minititle|BaseTrain}}
| | #redirect [[non-existent redirect to prevent Special:ShortPages being filled]] |
| {{IO|SetSpeed|Set the speed of the train, as a ratio of max speed [0, 1]|param=float}}
| | {{APH|}} |
| {{IO|SetSpeedDir|Set the speed of the train, as a ratio of max speed. Negative values reverse the direction [-1, 1]|param=float}}
| |
| {{IO|SetSpeedReal|Set the speed of the train. Must be a positive value from 0 to max speed.|param=float}}
| |
| {{IO|SetSpeedDirAccel|Accel/Decel to the specified speed, as a ratio of max speed. Negative values reverse the direction [-1, 1]|param=float|not={{l4d}}}}
| |
| {{IO|SetSpeedForwardModifier|Applies the given modifier to all forward speeds. [0, 1]|param=float|removed={{l4d}}}}
| |
| {{IO|TeleportToPathTrack|Teleport the train to the designated path track. This can be in a new path.|param=targetname|removed={{l4d}}}}
| |
| :{{note|The above three inputs appear to have been added to [[Source 2007]] games post-release for TF2's Payload mode, but did not make it into later games, resulting in their apparent "removal". However, <code>SetSpeedDirAccel</code> did later get ported in {{l4d2|4}}.}}
| |
| {{IO|MoveToPathNode|Move the train to a specific path_track, stopping when it gets there. Must be in the same path.|param=targetname|since={{portal2}}}}
| |
| {{IO|TeleportToPathNode|Teleport to another path_track and stop the train. This can be in a new path.|param=targetname|since={{portal2}}}}
| |
| {{IO|LockOrientation|Lock the current orientation of the train.|since={{portal2}}}}
| |
| {{IO|UnlockOrientation|Unlock the current orientation of the train.|since={{portal2}}}}
| |
| {{IO|SetMaxSpeed|Set a new max speed for the train.|param=float|since={{portal2}}}}
| |
| {{IO|Stop|Stop the train.}}
| |
| {{IO|StartForward|Start the train moving forward.}}
| |
| {{IO|StartBackward|Start the train moving backward.}}
| |
| :{{bug|If the train's corresponding [[path_track]]s do not have "New Train Speed" set to a nonzero number, StartBackward will exhibit undesired behavior including the train freezing or moving in the wrong direction. This bug can be a pain if the train needs to ride through the path_track again at a different speed. This can be fixed by firing an "addOutput speed '#'" input at the path_track in question.}} | |
| {{IO|Resume|Resume the train moving in the current direction after it was stopped via the <code>Stop</code> or <code>Toggle</code> input.}}
| |
| {{IO|Reverse|Reverse the direction of the train.}}
| |
| {{IO|Toggle|Toggle the train between start and stop.}} | |
| </onlyinclude>[[Category:Input Templates|BaseTrain]]
| |
Note:Archived page history
Important:These pages are linked often from page history logs so Special:WhatLinksHere will not show anything.