Creating a wall light

Introduction

In this tutorial you will learn how to make a wall light that is seen in the Portal test chambers.

The final effect

Steps

Step 1

Create a room for the light to be in, for the sake of this tutorial wel will use a 384*384*256 room with walls 16 units thick. Ensure the roof is touching the walls only by its edges.

Step 2

Step 2

Texture the edges of the roof with the same texture you used for your roof.

Step 3

Step 3

Shrink the roof by four on each end, so in this case, from 384*384 -> 376*376

Step 4

Step 4

Create a 4*16 block with the invisible texture and put it right beside your newly shrunk roof. They should fit so there are no leaks.

Step 5

Step 5

Copy the invisible blocks and re-texture them to have nodraw. Move them higher above the invisible blocks so you can easily preform step 6

Step 6

Step 6

Texture the bottom of the nodraw 4*16 blocks to light_recessedcool002. Rotate the recessed texture with the face edit tool so it is parallel with the block, with the lighter side of the gradient facing the inside of the room. TIP: Change the light_recessedcool002 textures lightmap resolution to 8 to create a more consistant glow

Step 7

Step 7

Move the nodraw blocks to sit on top of the invisible blocks.

Step 8

Step 8

Select all the top walls and pull them up so they enclose the invisible blocks.

Step 9

Step 9

Add an overlay with decals/overlay_light_gradient, and change the vstart/end to .99 instead of 1.

Step 10

Step 10

Resize to fit, and move inside of the hole.

Step 11

Step 11

Repeat for every wall

Step 12

Compile your map, and ensure there are no leaks.